Daikin RoCon UFH Manuel D'installation Et De Fonctionnement page 57

C: Setting the interval
If the Interval function is active, the pump is automatically switched on.
The following switching data can be programmed:
• Time
• Weekday
• Duration of interval
- To disable the Interval function, you must set the duration of the interval to
"0".
Fig. 7-17: Programming the Interval function
1. Keep pressing the Menu key until the Interval function screen is displayed.
2. Hold down the Set key for 3 seconds.
- The "Hour" digits flash.
3. Keep pressing the Menu key until the required hour is displayed.
4. Press the Set key to save the hour.
- The "Minute" digits flash.
5. Keep pressing the Menu key until the required minute is displayed.
6. Press the Set key to save.
- The "Duration" digits flash.
7. Keep pressing the Menu key until the required interval (0 to 15 minutes) is dis-
played.
8. Press the Set key to save the interval.
- The "Weekday" digits flash.
9. Keep pressing the Menu key until the required weekday (1 = Monday to
7 = Sunday) is displayed.
10.Press the Set key to save.
RoCon UFH
Operation
A. Menu "Interval function"
B. Time (format: 24 h)
C. Weekday (3 = Wednesday)
D. Indicator "Menu"
E. Indicator "Interval function"
F. Switch on duration of switching output
"Interval" (0 to 15 minutes)
EN
55