Daikin RoCon UFH Manuel D'installation Et De Fonctionnement page 58

D: Programming the Additional Pump Running Time function
You can program an additional pump running time from 0 to 15 minutes. To disable
the Additional Pump Running Time function, you must set the duration to the value
"0".
A
Fig. 7-18: Programming the Additional Pump Running Time function
The indicator for the switching output Additional Pump Running Time is only dis-
played if the menu Additional Pump Running Time is active or if the function Addi-
tional Pump Running Time is running.
1. Keep pressing the Menu key until the Additional Pump Running Time function
indicator "Pu" is displayed.
2. Hold down the Set key for 3 seconds.
- The digits for the switch on duration blink.
3. Press the Menu key to adjust the required value.
4. Press the Set key to save.
RoCon UFH
Operation
B
A. Indicator "Menu Additional Pump
B. Switch on duration (0 - 15 minutes)
C. Indicator "Menu" active
D. Switching output Additional Pump
C
D
Running Time Function" active
Running Time function active
EN
56