Squeegee Installation; Solution Tank Filling - Nilfisk Advance ecoflex SC500 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Squeegee installation

1.
Install the squeegee (A, Fig. 3) and fasten it to the bracket
(C) with the handwheels (B).
2.
If necessary, adjust the squeegee with the knob (D) so that
the rear blade (E) and front blade (F) touch the floor as
shown in the figure.

Solution tank filling

CAUTION!
Use only low-foam and non-flammable
detergents, intended for automatic scrubber
applications.
WARNING!
When using floor cleaning detergents, follow
the instructions on the labels of the detergent
bottles.
To handle floor cleaning detergents, wear
suitable gloves and protections.
NOTE
If the machine is equipped with EcoFlex™ system
pour clean water in the tank, otherwise pour solution.
1.
Ensure that the solution valve (18) is open (18-A).
2.
To fill the solution tank (21) use the front filler (22), or open
the cap (24) to access the side filler.
(For machines without EcoFlex™ system)
3.
Fill the tank (21) with a solution suitable for the work to be performed.
Do not fill the tank completely, leave a few inches from the edge. Use the level hose (13) as reference.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40 °C.
(For machines with EcoFlex™ system)
4.
Fill the tank (21) with clean water. Use the water removable filler hose (23).
Do not fill the tank completely, leave a few inches from the edge. Use the level hose (13) as reference.
The water temperature must not exceed 40 °C.
Detergent tank filling (For machines with EcoFlex™ system)
5.
Lift the cover (34) and check that the recovery tank (33) is empty; if not, empty it using the drain hose (12).
6.
Close the cover (19).
7.
Grasp the handle (16) and carefully lift the tank (33).
8.
Fill the tank (25) with a detergent suitable for the work to be performed (highly concentrated detergent).
Do not fill the detergent tank completely, leave a few inches from the edge.
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
NOTE
To accelerate filling of the hoses and system operation (with a new system, if the system has been emptied for cleaning,
etc.), it is a good idea to drain the EcoFlex™ system once or several times (see the procedure in the Maintenance
chapter).
11/14
INSTRUCTIONS FOR USE
F
Figure 3
9099974000 - SC500
ENGLISH
C
A
B
D
B
E
P100843
13

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Advance 9087350020Advance 9087351020Sc500

Table des Matières