Machine Start And Stop; Stopping The Machine; Machine Operation (Scrubbing/Drying) - Nilfisk Advance ecoflex SC500 Instructions D'utilisation

ENGLISH

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. To turn on the machine, insert the operator key (41) in its slot on the control panel (3); if the key is already inserted, press the
push-button (42).
3. In the first 2 seconds after machine start-up, the multifunction display (50) indicates the machine working hours (50-A) and the
type of batteries installed (50-B).
NOTE
Check the battery charge level.
When the multifunction display shows at least one segment of the battery symbol (50-C) which is on but not flashing, the
machine is ready for use.
When the battery symbol (50-C) shows just one segment flashing, the batteries have to be charged (see the procedure in
Maintenance chapter).
4. Drive the machine to the area it is required by starting it with your hands on the handlebar (1) and pushing the paddle (2)
forward to move forward, and backwards to move in reverse. The speed can be adjusted by pressing the paddle (2) more or
less. The maximum speed can be set with the push-buttons (45).

Stopping the machine

5. Stop the machine by releasing the paddle (2).
6. Turn off the machine by pressing push-button (42), or by removing the operator key (41) from the control panel (3).
NOTE
If the machine is on but not working, it automatically turns off after 5 minutes.
7. Make sure that the machine cannot move independently.
CAUTION!
In the event of an emergency when you must stop all machine functions immediately, disconnect the battery
connector (9).
Reset the machine functions by connecting again the connector.

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. Lower the squeegee (29) with the pedal (8).
3. Press the One-Touch™ push-button (43) to lower the brush deck and start scrubbing and drying.
4. Start cleaning by manoeuvring the machine and pressing the paddle (2).
If necessary, adjust the maximum speed with the push-buttons (45).
5. Adjust the solution flow by pressing the push-button (48) as necessary, depending on the type of cleaning to be performed.
NOTE
For the first 3 flow levels (Fig. 4), the amount of solution dispensed is automatically adjusted according to the machine
speed, in order to obtain a constant amount of solution per linear meter of cleaning.
Level 4 (when enabled) supplies the maximum possible quantity of detergent solution, regardless of the machine speed
(to enable or disable this, see the Super User key section in the Maintenance chapter).
The level 0 closes the solution flow completely.
Lev.
1
0,75 cl/m
14
INSTRUCTIONS FOR USE
Lev.
Lev.
2
1,5 cl/m
SC500 - 9099974000
Lev.
4
3
3,0 cl/m
Figure 4
Lev.
0
2,8 l/min OFF
P100844
11/14