After Using The Machine; Machine Long Inactivity; Maintenance; Scheduled Maintenance Table - Nilfisk Advance ecoflex SC500 Instructions D'utilisation

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brush as shown in the relevant paragraph.
2. Remove the operator key (41).
3. Empty the tanks (21) and (33) as shown in the relevant paragraphs.
4. Perform the daily maintenance procedures (see the Maintenance chapter).
5. Store the machine in a clean and dry place, with the brush and the squeegee lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After using the machine paragraph.
2. For versions with EcoFlex™ system, empty the detergent tank (25) and clean the system with a draining cycle (see the
procedure in Maintenance chapter).
3. Close the solution tank valve (18-B).
4. Disconnect the battery connector (9).

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
CAUTION!
When the Service icon
scheduled maintenance.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery Charging
Squeegee Cleaning
Brush/pad cleaning
Recovery tank and debris tray cleaning, and cover gasket check
EcoFlex™ system cleaning and draining
Squeegee Blade Check and Replacement
Solution Filter Cleaning
Battery (WET) fluid level check
Squeegee blade replacement
Brush motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
(1) This maintenance procedure must be performed by an authorised Nilfisk Service Center.
11/14
appears on the display (50), contact an authorised Nilfisk Service Centre for
Daily, after us-
ing the machine
INSTRUCTIONS FOR USE
Weekly
9099974000 - SC500
ENGLISH
Every six
Yearly
months
(1)
(1)
17