Safety Information - Scheppach dp13 Traduction Du Manuel D'origine

GB
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial appli-
cations. Our warranty will be voided if the equipment
is used in commercial, trade or industrial businesses
or for equivalent purposes.

5. Safety information

m Caution!
Read all safety regulations and instructions. Any er-
rors made in following the safety regulations and in-
structions may result in an electric shock, fire and/or
serious injury. Keep all safety regulations and instruc-
tions in a safe place for future use.
m Warning! To protect against electric shock, injury
and fire the following basic safety precautions must
be observed when using power tools.
Read and follow these instructions before using the
equipment and keep the safety information in a safe
place.
1. Keep work area clean
Cluttered areas and benches invite injuries.
2. Consider work area environment
Don't expose power tools to rain. Don't use power
tools in damp or wet locations. Keep work area
well lit. Don't use power tools in presence of flam-
mable liquids or gases.
3. Guard against electric shock
Prevent body contact with grounded surfaces
(e.g. pipes, radiators, ranges refrigerators).
4. Keep children away
Do not allow other persons to touch the equipment
or cable, keep them away from your work area.
5. Store idle tools
When not is use, tools should be stored in dry,
high, or locked-up place, out of the reach of chil-
dren.
6. Don't force tool
It will do the job better and safer at the rate for
which it was intended.
7. Use right tool
Don't force small tools or attachments to do the
job of heavy duty tool. Don't use tools for purpos-
es not intended.
8. Dress properly
Do not wear loose clothing or jewellery. They can
be caught in moving parts. Rubber gloves and
non-skid footwear are recommended when work-
ing outdoors. Wear protective hair covering to
contain long hair.
9. Use safety glasses
Also use face or dust mask if cutting operation is
dusty.
10. Don't abuse cord
Never carry tool by cord or yank it to disconnect
it from receptacle. Keep cord from heat, oil and
sharp edges.
20 / 152
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
11. Secure work
Use clamps or a vice to hold work. It's safer than
using your hand and it frees both hands to oper-
ate tool.
12. Don't overreach
Keep proper footing and balance at all times.
13. Maintain tools with care
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating
and changing accessories. Inspect tool cords pe-
riodically and, if damaged, have repaired by au-
thorized service facility. Inspect extension cords
periodically and replace if damaged. Keep han-
dles dry, clean and free from oil and grease.
14. Disconnect tools
When not in use, before servicing, and when
changing accessories.
15. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and
adjusting wrenches are removed from tool before
turning it on.
16. Avoid unintentional starting
Don't carry plugged-in tool with finger on switch.
Be sure switch is off when plugging in.
17. Outdoor use extension cords
When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.
18. Stay alert
Watch what you are doing. Use common sense.
Do not operate tool when you are tired.
19. Check damaged parts
Before further use of the tool, a guard or other
part that is damaged should be carefully checked
to determine that it will operate properly and per-
form its intended function. Check for alignment of
moving parts, binding of moving parts, breakage
of parts, mounting, and any other conditions that
may affect its operation. A guard or other part
that is damaged should be properly repaired or
replaced by an authorized service-center unless
otherwise indicated elsewhere in this instructions
manual. Have defective switches replaced by
an authorized service-center. Do not use tool if
switch does not turn it on and off
20. m Warning!
The use of any other accessory or attach
other than recommended it this operating instruc-
tion or the catalog may present a risk of personal
injury.
21. Have your tool repaired by an expertThis elec-
tric appliance is in accordance with the relevant
safety rules repairing of electric appliances may
be carried out only by experts otherwise it may
cause considerable danger for the user.
22. Connect the dust extraction device
Wherever there are facilities for fitting a dust ex-
traction system, make sure it is connected and
used.
ment