Safety Information - Scheppach dp13 Traduction Du Manuel D'origine

GB
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the equipment is used
in commercial, trade or industrial businesses or for
equivalent purposes.

5. Safety information

m Caution!
Read all safety regulations and instructions. Any errors
made in following the safety regulations and instruc-
tions may result in an electric shock, fire and/or serious
injury. Keep all safety regulations and instructions in a
safe place for future use.
m Warning! To protect against electric shock, injury
and fire the following basic safety precautions must be
observed when using power tools.
Read and follow these instructions before using the
equipment and keep the safety information in a safe
place.
1. Keep work area clean
Cluttered areas and benches invite injuries.
2. Consider work area environment
Don't expose power tools to rain. Don't use power
tools in damp or wet locations. Keep work area well
lit. Don't use power tools in presence of flammable
liquids or gases.
3. Guard against electric shock
Prevent body contact with grounded surfaces (e.g.
pipes, radiators, ranges refrigerators).
4. Keep children away
Do not allow other persons to touch the equipment
or cable, keep them away from your work area.
5. Store idle tools
When not is use, tools should be stored in dry, high,
or locked-up place, out of the reach of children.
6. Don't force tool
It will do the job better and safer at the rate for
which it was intended.
7. Use right tool
Don't force small tools or attachments to do the job
of heavy duty tool. Don't use tools for purposes not
intended.
8. Dress properly
Do not wear loose clothing or jewellery. They can be
caught in moving parts. Rubber gloves and non-skid
footwear are recommended when working outdoors.
Wear protective hair covering to contain long hair.
9. Use safety glasses
Also use face or dust mask if cutting operation is
dusty.
10. Don't abuse cord
Never carry tool by cord or yank it to disconnect it
from receptacle. Keep cord from heat, oil and sharp
edges.
11. Secure work
Use clamps or a vice to hold work. It's safer than
using your hand and it frees both hands to operate
tool.
20 / 132
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
12. Don't overreach
Keep proper footing and balance at all times.
13. Maintain tools with care
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodi-
cally and, if damaged, have repaired by authorized
service facility. Inspect extension cords periodically
and replace if damaged. Keep handles dry, clean
and free from oil and grease.
14. Disconnect tools
When not in use, before servicing, and when chang-
ing accessories.
15. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and
adjusting wrenches are removed from tool before
turning it on.
16. Avoid unintentional starting
Don't carry plugged-in tool with finger on switch. Be
sure switch is off when plugging in.
17. Outdoor use extension cords
When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.
18. Stay alert
Watch what you are doing. Use common sense. Do
not operate tool when you are tired.
19. Check damaged parts
Before further use of the tool, a guard or other part
that is damaged should be carefully checked to
determine that it will operate properly and perform
its intended function. Check for alignment of moving
parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect
its operation. A guard or other part that is dam-
aged should be properly repaired or replaced by an
authorized service-center unless otherwise indicated
elsewhere in this instructions manual. Have defec-
tive switches replaced by an authorized service-
center. Do not use tool if switch does not turn it on
and off
20. m Warning!
The use of any other accessory or attach
other than recommended it this operating instruc-
tion or the catalog may present a risk of personal
injury.
21. Have your tool repaired by an expertThis electric
appliance is in accordance with the relevant safety
rules repairing of electric appliances may be carried
out only by experts otherwise it may cause consid-
erable danger for the user.
22. Connect the dust extraction device
Wherever there are facilities for fitting a dust extrac-
tion system, make sure it is connected and used.
Warning! This electric tool generates an electromag-
netic field during operation. This field can impair
active or passive medical implants under certain
conditions. In order to prevent the risk of serious or
deadly injuries, we recommend that persons with
medical implants consult with their physician and the
manufacturer of the medical implant prior to operating
the electric tool.
ment