Troubleshooting - Aerogen Solo Manuel D'utilisation Du Système

Troubleshooting

If these suggestions do not correct the problem, discontinue use of any
device and contact your local Aerogen sales representative.
Table 2. Aerogen Pro-X Controller Troubleshooting
If this happens:
The 30 Min. indicator
flashes during
nebulisation.
Battery will not
recharge.
Controller is
connected to the
AC/DC adapter and
the battery charging
light is illuminated
green and the 30
Min. indicator light is
flashing.
Battery will not retain
initial charge.
The 30 Min. or
Continuous light
illuminates, but
aerosol is not visible.
30 Min. or Continuous
indicator does not
light when On/Off
power button is
pressed.
The error indicator
light illuminates.
Aerogen® Solo System Instruction Manual
It could mean:
Battery power is low.
It may be time to replace
the battery.
Rechargeable battery
may need to be
replaced.
No medication in
nebuliser.
It may be time to replace
the nebuliser.
There is no power to the
system.
Rechargeable battery is
depleted.
The controller cable is
incorrectly connected
to the nebuliser,
or electronics are
malfunctioning.
Try this:
Recharge battery (see
Recharging the Battery).
Contact your local Aerogen
sales representative.
Contact your local Aerogen
sales representative.
Refill medication through
filler cap in the nebuliser
(see page 25).
See Warranty and Life
of Product. Refer to the
Aerogen Solo parts list by
visiting www.aerogen.com.
Verify that AC/DC adapter
is securely attached to
controller.
Recharge battery (see
Recharging the Battery).
Verify that controller cable
is correctly connected to
both the nebuliser and the
controller.
31