Krick RoMarin FLB 1 Mode D'emploi page 72

Railing on the hull
No. Description
8.20 Keeper
8.21 Self-tapping screw
8.22 Rear railing pull
8.23 Railing stanchion straight
8.24 railing pull fore
8.25 Railing stanchion angled
8.26 Double cross bollard
8.27 Lips
8.28 Flange
8.29 Ties
Bend the rails 8.22 according to the drawing. Attach the railing stanchions 8.23 to the cables. Insert the railing
stanchions into the holes in the deck. Drill out the holes in the deck to fit.
Glue the wires to the supports. Now bend the ends of the upper railing pull downwards towards the deck. Bend
both sides the same. Drill a 1 mm hole in the deck and insert the end.
After painting, glue the railing to the deck.
For the front rails 8.24 cut 2 times 480 mm wire 1 mm. Bend the centre 240 mm over a round bar of 4 mm.
Pre-bend the bend of the railing along the inner hull edge. Attach the railing stanchions to the wires. Note that
the front stanchion is a straight stanchion 8.23. This must be placed first. Drill out the holes in the deck to fit.
Insert the railing supports into the holes and align the supports. Glue the wires to the supports. The protruding
ends can be cut off at the last railing support. Do not glue the railing to the deck until after painting.
8.24
8.23
Use the edge to pre-bend the railing
Fig.: Making the rail
Glue the lips together from parts 8.27 and 8.28. Glue 2 each 8.27 on top of each other and into the flange
8.28. Glue the double cross bollards 8.26 and lips 8.27 to the deck.
8.27 2*
Fig.: Lip
Status 25. August 2022
Ready made
Ready made
Brass wire
Ready made
Brass wire
Ready made
Ready made
Laser part
Laser part
Rope yarn
8.23
8.25
8.28
30
Dimensions
Plastic
D 2,2 * 6.5 Counters.
D 1 mm see drawing
3 D Print
D 1 see drawing
3 D Print
Plastic
Laserpl. 1,5
Laserpl. 1,5
D 1
© Krick Modelltechnik
Qty.
2
2
2
7 BS
2
14 BS
5 BS
8
4
6 BS
8.22
Bend ends