Krick RoMarin FLB 1 Mode D'emploi page 57

Fig.: Installing the chain downtube and chain tube
When the foredeck is glued, the chain down tube 2.21 and the chain tube 2.22 can be installed. The aligned
hole between the forecastle deck, deck and anchor pocket should be re-drilled with a 6 mm drill.
Push the chain tube 2.22 through to the deck. Coat the lower edge with glue so that it is glued to the deck
when it is placed on it. This will prevent water from the foredeck entering the hull.
Step 4, the superstructure
No. Description
4.1 Superstructure
4.2 Door
4.3 Window frame door
4.4 Cover box hose outlets
4.5 Front windows
4.6 Side windows
4.7 Rear windows
Fig.: Vacuum formed parts superstructure and cover box
Cut off the lower, flared edge of the superstructure and sand the edge flat so that the superstructure rests
evenly on the deck.
Cut out the cover box and fit it to the front wall of the superstructure.
Status 25. August 2022
2.22
2.21
4.4
Vac formed
Laser part
Laser part
Vac formed
Laser part
Laser part
Laser part
4.1
15
Dimensions Qty.
1
Laserpl. 1 2
Laserpl. 1 2
1
Laserpl. 1 1
Laserpl. 1 2
Laserpl. 1 1
© Krick Modelltechnik