Krick RoMarin FLB 1 Mode D'emploi page 64

Cut the lamp holders 5.8 to length. Drill the tube 5.4 according to the drawing. Push the tubes 5.5 and 5.6 5
mm into the larger one. Solder or glue the light pole. Glue or solder the mast foot 5.10 and the foot flange 5.11.
Fit the deck floodlights 5.9 with bulbs and glue them to the lamp holders. Run the cables down through the
rear hole in the mast.
Glue together the drive for height adjustment from the 3 parts 5.12 and glue it to the side of the light pole.
5.13
Fig.: Speaker
Glue together parts 5.14 the speaker holder and glue on 2 speakers. Make 2 times.
5.16
Fig.: Lamp board Navigation lamp
Glue together the port and starboard lamp boards from parts 5.15 - 5.17 and paint them. Paint the lamps,
taking care not to cover the lenses with paint. Also note that the lamps have different beam angles.
Navigationlamps: 112,5°
Toplight: 225°
Stern light: 135°
5.24
Fig.: Hose box
Glue the hose box together at an angle from parts 5.21 - 5.24. The box can now be painted.
Status 25. August 2022
5.14
5.17
5.15
5.21
Starboard green
5.18
5.23
5.22
22
Portside red
Bow
© Krick Modelltechnik