Krick RoMarin FLB 1 Mode D'emploi page 54

If the model is equipped with a water pump, the intake tube can now be installed before the deck is glued on.
This makes it easy to glue the tube to the bottom of the hull.
No. Description
9.23 Intake tube
9.25 Pump
Fig.: Installing the intake tube
Drill the hole D 4mm through the hull as specified by the RC plate.
Bevel the intake pipe at the bottom according to the shape of the hull and push it through the hull. The tube
should be flush with the underside of the hull.
If this is the case, fix the pipe with superglue and then glue it tight with Stabilit-Express.
Now the prepared deck can be applied.
Fig.: Installing the deck
Insert the deck into the hull. If necessary, sand the edge a little. Fix the deck in some places with superglue.
When it lies neatly in the hull, run superglue into the edge all around.
Status 25. August 2022
Brass tube
Ready made
9.23 Intake tube
9.25 Pump
12
Dimensions
D 3,1 * D4 * 45 mm
© Krick Modelltechnik
Qty
1
1 n.e.