Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation of RC plate
No.
Description
1.14
RC-Plate
1.15
Support frame
1.16
Reinforcement pump nut
1.17
Pump reinforcement
1.18
Hexagon nut
1.19
Screw
1.20
Washer
1.16
1.17
Fig.: Assembly of pump reinforcement
1.18
1.16 - 1.17
1.2 - 1.8
Place the drive unit and RC plate 1.14 in the hull, whereby the motor bulkhead must engage in the plate. The
bulkhead should fit smoothly in the groove of the RC plate 1.14.
Insert support bulkhead 1.15 and glue it only to the RC plate.
Push the RC plate backwards to the stop. Glue the RC plate in the hull with super glue.
Align the motor bulkhead so that the motor and the ship's shaft are flush. Check the alignment with a straight
piece of a laser plate. Glue the motor bulkhead with super glue.
After drying, turn the model over.
Status 25. August 2022
Laser part
Laser part
Laser part
Ready made
1.18
Glue the two parts 1.16 Reinforcement pump together and glue
them onto part 1.17. Press in the hexagon nuts 1.18 and then
glue them under the RC plate 1.14.
1.15
Fig.: Installation of drive and RC plate
5
Laserpl. 1,5
1
Laserpl. 1,5
1
Laserpl. 1,5
2
Laserpl. 1,5
1
2
M3 * 10
2
D 3,2
2
1.14
1.1
© Krick Modelltechnik
Publicité
Table des Matières
