Dimensions Qty Laserpl; Laserpl - Krick RoMarin FLB 1 Mode D'emploi

Step 3, Deck and coaming
No. Description
3.1 Deck
3.2 Hatch frame
3.3 hatch
3.4 Coaming
3.5 Bulwark
3.6 Fore deck/monitor deck
3.7 Splash board
3.8 Splash board
3.9 Splash board
3.10 Step
3.11 Portholes
3.12 Glazing
3.13 Reinforcement
3.1
Fig.: Deck, underside reinforcement strips and hatch frame
60°
Fig.: Deck, top side coaming and hatch cover
Fit and glue the coaming strips 3.4 for the longitudinal edges. Bevel the front edges approx. 60° above deck.
Fit and glue in the transverse strips of the coaming. Glue the front crossbar at an angle corresponding to the
60° so that the superstructure can be easily slid over it later.
Status 25. August 2022
3.13
Dimensions
Laser part

Laserpl. 1,5

Laser part Laserpl. 1,5
Laser part Laserpl. 1,5
Laser part Laserpl. 1,5
Vac formed
Laser part Laserpl. 1,5
Laser part Laserpl. 1,5
Laser part Laserpl. 1,5
Laser part Laserpl. 1,5
Laser part Laserpl. 1,5
Laser part Laserpl. 1
Vivac 0,7 * 15 * 90 mm
ABS Profile 3 * 3 * 1000 mm
3.2
3.1
11
Qty
1
1
1
4
1
1
1
2
2
2
4
2
1
Frame the deck cut-out from
underneath with the reinforcing strips
3.13. Also glue the hatch frame 3.2 to
the bottom of the cut-out so that there
is an equal support edge.
3.3
3.4
© Krick Modelltechnik