Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
For the lacquering, you can follow the illustrations on the cardboard box.
Notes on the remote control system
It is recommended to install the intended RC components. If other components are used, you can follow the
installation diagram. Carry out the arrangement accordingly.
Start up the radio control system according to the instructions supplied in order to bring the servos into
neutral position before installation - the stick and trim lever on the transmitter must be in the centre position.
Fix the plug connections in the fuselage so that they cannot come into contact with seepage water.
Note on special functions
The model is suitable for a wide range of special functions. Lighting, radar and fire monitor can be made
functional. Of course, sound modules can also be installed.
Note on the parts list
n.e.
=
not included
BS
=
included in the fitting set
BSR
=
Special fittings set imitation chequer plate
Stage 1, fuselage and propulsion system
No.
Description
1.1
Hull
1.1
Drill the 4 mm holes for the stern tube and rudder bearing.
Status 25. August 2022
5 mm
MS
Ku
Tzt
Vac formed
Mark the edge of the hull all around with the help of a piece of
scrap wood 5 mm thick and cut it down.
Fig.: Hull, trimming the thermoformed part
3
=
Brass
=
Plastic
=
Vacuum formed part
Dimensions in mm
© Krick Modelltechnik
Qty.
1
Publicité
Table des Matières
