Krick RoMarin FLB 1 Mode D'emploi page 68

Cut the handrails 7.1 - 7.4 to length, fit split pins 7.5 and sleeves 7.6 and insert them through the
corresponding holes of the superstructure. Bend the split pins inside and glue.
Drill the holes for the door handles 7.7. Bend the handles and glue them in place.
Assemble the searchlight 7.8 and glue it to the roof. Guide the cables downwards.
Stick the rectangular loudspeaker 8. onto the roof.
Push the bulbs for the blue lights through the funnel ends and guide them down through the funnel. Drill a hole
in the superstructure under the funnel. Paint the bases on the blue lights black and glue them to the funnels.
Glue together the 4 antennas from parts 7.11 and 7.12 and insert them into the holes in the funnel ends.
Glue the portholes 4.31 to the superstructure and behind them glue the glazing 4.32 in the superstructure from
inside.
Insert the straight railing supports 7.13 into the holes provided. Do not glue until the pull-throughs have been
installed and the railing has been painted.
Fit the prepared lamp boards with navigation lights on the superstructure. Cut the profile pieces 5.20 to size
and glue them under the lamp shelves. Adjust according to the roof angles.
1
7.14
Fig.: Railing superstructure, speakers
No. Description
7.14 Railing pull-through, left
7.15 Railing pull-through, right
7.16 Railing pull-through, right
Make the rails 7.14 - 7.16 according to the 1:1 drawing on the enclosed sheet. Attach the railing stanchions to
the railing pulls.
Drill 1 mm holes flush with the funnels and push in the pulls.
Fit the complete railing, align it and glue the rails and supports together. The railing is finally glued to the
superstructure after painting.
Stick the prepared loudspeaker units onto the radar bridge.
Status 25. August 2022
5.13-5.14
Messingdraht
Messingdraht
Messingdraht
26
7.15
7.16
Dimensions Qty.
D 1 n. Zeichnung 2
D 1 n. Zeichnung 2
D 1 n. Zeichnung 2
© Krick Modelltechnik