Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.25
7.23
7.22
7.21 do not glue
Fig.: Assembling the coupling housing, installing the radar gearmotor
Glue the coupling housing together from parts 7.22 - 7.25.
Attention: Do not glue the motor plate, it is screwed to the holder with the screws 7.27.
Now glue the coupling housing centrically under the body.
Screw the motor plate 7.21 to the motor with motor screws 7.29. Push the coupling hose onto the motor shaft.
If necessary shorten the coupling hose a little, it should not touch the body, and screw it to the coupling
housing with the screws 7.27.
Insert the radar antenna with the shaft and connect it to the coupling.
Step 8, Finishing the Hull
No.
Description
8.1
Checker plate rear
8.2
Checker plate hatch
8.3
Chequer plate centre r/l
8.4
Checker plate fore deck
8.5
Chequer plate step Superst.
8.6
Checker plate step foredeck
8.7
Checker plate step rear
8.8
Shaft
8.9
Winch housing
8.10
Capstan head
8.11
Chain wheel
8.12
Brake
8.13
Spindle
8.14
Handwheel
8.15
Holder
8.16
Fender
8.17
Fixing iron
8.18
Flagg
8.19
Flagpole
Status 25. August 2022
7.24
7.26
Laser part
Laser part
Laser part
Laser part
Laser part
Laser part
Laser part
Brass wire
Ready made
Ready made
Ready made
Ready made
Brass wire
Ready made
Laser part
ASA Dowel
Brass wire
Ready made
Ready made
28
7.19-7.20,7.29
Dimensions
Qty
Laserpl. Checker
1
Laserpl. Checker
2
Laserpl. Checker
1
Laserpl. Checker
1
Laserpl. Checker
1
Laserpl. Checker
2
Laserpl. Checker
2
D 2 * 35
1
3 D Print
1
1
1
3 D Druck
1
D 1 *15 mm
1
Plastic
1
Laserpl. 1
6
D 6 * 30
6
D 1 * 20
4
Cloth
1
3 D Print
1
© Krick Modelltechnik
BSR
BSR
BSR
BSR
BSR
BSR
BSR
BS
BS
BS
BS
BS
BS
BS
BS
Publicité
Table des Matières
