CAME ZLX24MA Mode D'emploi page 81

Enable password
Set a 4-digit password. The password will be requested to anyone who wants to access the main menu.
H3
Forgotten password
If you lose the password, you will need to reset the board to its factory settings. See [Factory reset].
Factory reset
To restore the electronic board data to factory settings:
Disconnect the control board from the power supply and wait for it to switch off .
Press and hold the < and > buttons, then reconnect the control board to the power supply.
Continue to press and hold the < > buttons until [ON/OFF] is displayed.
Select [ON].
Press ENTER to confi rm.
When you reset the control board, all saved users, set times and calibration operations are deleted.
BUS device status
Show the status of all devices that can be connected to the BUS and managed by the fi rmware in use.
Key
b = BUS photocells
d = BUS selector
L = BUS fl ashing beacon
<n> is the device number.
<x> is the device status.
H4
OFF (Default)
ON
Use the arrows and the Enter button to dial the desired code.
b<n>.<x>
<n> from 1 to 8
d<n>.<x>
<n> from 1 to 7
L<n>.<x>
<n> from 1 to 2
<x> device status
|| = Confl icting address
o = Working
c = Working with alarm signal
F = Device fault
- = No communication or not present