CAME ZLX24MA Mode D'emploi page 46

GENERAL PRECAUTIONS FOR INSTALLERS
Important safety instructions.
Please follow all of these instructions. Improper installation may cause
serious bodily harm.
Before continuing, please also read the general precautions for users.
Only use this product for its intended purpose. Any other use is hazardous. •
The manufacturer cannot be held liable for any damage caused by improper,
unreasonable or erroneous use. • This product has been designed to be assembled
to partly completed machinery and/or equipment so as to build machinery as
regulated by the Machinery Directive 2006/42/EC. • The fi nal installation must
comply with the Machinery Directive (2006/42/EC) and the European reference
standards in force. • The manufacturer declines any liability for using non-original
products, which would also void the warranty. • All operations indicated in this
manual must be carried out exclusively by skilled and qualifi ed personnel and in
full compliance with the regulations in force. • The device must be installed, wired,
connected and tested according to good professional practice, in compliance
with the standards and laws in force. • Make sure the mains power supply
is disconnected during all installation procedures. • All the components (e.g.
actuators, photocells and sensitive edges) needed for the fi nal installation to comply
with the Machinery Directive (2006/42/EC) and with the reference harmonised
technical standards are specifi ed in the general CAME product catalogue or on
the website www.came.com. • Check that the temperature ranges given are
suitable for the installation site. • Make sure that no direct jets of water can wet
the product at the installation site (sprinklers, water cleaners, etc.). • Make sure
you have set up a suitable dual-pole cut-off device along the power supply that is
compliant with the installation rules. It should completely cut off the power supply
according to category III surcharge conditions. • Demarcate the entire site properly
to prevent unauthorised personnel from entering, especially minors. • Use suitable
protection to prevent any mechanical hazards due to persons loitering within the
operating range of the operator. • The electrical cables must pass through special
pipes, ducts and cable glands in order to guarantee adequate protection against
mechanical damage. • The electrical cables must not touch any parts that may
overheat during use (such as the motor and transformer).