CAME ZLX24MA Mode D'emploi page 72

Command 2-7
Associate a command to the connected device on 2-7.
F7
Passage-open warning light
It signals the gate status.
The device is connected to output/terminal 5.
F10
Encoder
Use the encoder input from the motor.
The parameter is only available for motors that have an encoder.
F11
Closing thrust
When the leaves reach the closing limit-switch, the operator thrusts them towards the strike plate for a second.
F13
Thrust
Before every opening or closing manoeuvre, the leaves thrust inwards to release the electric lock.
The thrust motion is performed during opening or closing, depending on where the electric lock is active (see
function F17).
F16
Electric lock
Associate the electric lock release with a command.
F17
0 = Step-by-step (default)
1 = Sequential
0 = Warning light on (default) - The warning light stays on when the gate is moving or
open.
1 = Warning light fl ashing - The warning light fl ashes every half second when the gate is
opening and stays on when the gate is open. The light fl ashes every second when the gate
is closing, and remains off when the gate is closed.
ON (Default)
OFF
OFF (Default)
1 = Minimum thrust
2 = Medium thrust
3 = Maximum thrust
OFF (Default)
ON
OFF (Default)
1 = From closed
2 = From open
3 = From open and closed
4 = Continue