CAME ZLX24MA Mode D'emploi page 71

CX input
Associate a function with the CX input.
F2
CY input
Associate a function with the CY input.
F3
Safety devices test
Check that the photocells connected to the inputs are operating correctly, after each opening and closing command.
Run the test by connecting the photocells to the TS terminal [see paragraph on Safety devices].
F5
Hold-to-run
With the function active, the operator stops moving (opening or closing) when the control device is released.
When the function is active, it excludes all other control devices.
F6
OFF (Default)
C1 = Reopen while closing (photocells)
C2 = Reclose while opening (photocells)
C3 = Partial stop Only with [Automatic close] activated.
C4 = Obstacle standby (photocells)
C7 = Reopen while closing (sensitive edges)
C8 = Reclose while opening (sensitive edges)
C13 = Reopen while closing, with immediate stop once the obstruction has been removed,
even if the gate is not in motion
r7 = Reopen while closing (sensitive edges with 8K2 resistor)
r8 = Reclose while opening (sensitive edges with 8K2 resistor)
2r7 = Reopen while closing (pair of sensitive edges with 8K2 resistor)
2r8 = Reclose while opening (pair of sensitive edges with 8K2 resistor)
OFF (Default)
C1 = Reopen while closing (photocells)
C2 = Reclose while opening (photocells)
C3 = Partial stop Only with [Automatic close] activated.
C4 = Obstacle standby (photocells)
C7 = Reopen while closing (sensitive edges)
C8 = Reclose while opening (sensitive edges)
C13 = Reopen while closing, with immediate stop once the obstruction has been removed,
even if the gate is not in motion
r7 = Reopen while closing (sensitive edges with 8K2 resistor)
r8 = Reclose while opening (sensitive edges with 8K2 resistor)
2r7 = Reopen while closing (pair of sensitive edges with 8K2 resistor)
2r8 = Reclose while opening (pair of sensitive edges with 8K2 resistor)
OFF (Default)
1 = CX
2 = CY
3 = CX+CY
OFF (Default)
ON