CAME ZLX24MA Mode D'emploi page 80

Motor test
Check the gate leaves open in the right direction.
With the function active, the > key opens the gate leaf connected to M2, and the < key opens the gate leaf connected to M1.
The movement continues while the key is pressed or until the end-of-travel limit switch is reached. When the key is released,
the movement stops.
If the leaf does not move in the correct direction, invert the motor phases.
The leaves will move at reduced speed.
A2
Travel calibration
Start the travel self-learning.
A3
Parameter reset
Restore the factory confi gurations except for: [users], [timers], [number of motors], [motor type], [CRP address], [limit-switch
inputs function], [RSE speed], [password] and the settings related to the travel calibration.
A4
Manoeuvre counter
View the number of total or partial operator manoeuvres (after maintenance).
The number of manoeuvres is the number shown multiplied by 100.
A5
Motor power
Setting power range of motors connected on M1 and M2.
The parameter is used only with generic motors [Function A1 set at 0].
A8
FW version
Display the fi rmware version and the GUI installed.
H1
----
OFF (Cancel operation)
ON (Run operation)
OFF (Cancel operation)
ON (Run operation)
Tot = total manoeuvres
Manoeuvres performed since the operator was installed.
Par = partial manoeuvres
Manoeuvres carried out after the last maintenance.
Under the [Par] parameter, press the ENTER key to reset the number of partial
manoeuvres. [Clr] will appear on the screen to confi rm deletion.
1 = Minimum power [up to 120W]
2 = Medium power (Default) [up to 200W]
3 = Maximum power [more than 200W]
Use the < > arrows to show the versions of the display board and the control board one
after the other.