CAME ZLX24MA Mode D'emploi page 78

Limit-switch function
Set the operation of the inputs for slowdown/end-of-travel switches.
The function only appears for motors confi gured for this purpose.
After modifying the function of the slowdown/end-of-travel inputs, recalibrate [Function A3]
If the inputs are used for slowdown, once calibration is complete, the board automatically sets the slowdown
points. These parameters can, however, be modifi ed. They allow for slowdown even if the slowdown switch is not
seen.
The type of input (N.O. or N.C.) can be modifi ed only with the generic motor [Function F73]. In all other cases,
use the type envisaged by the specifi c motor.
F72
Input type FC/FA
Set the type of inputs FC/FA
The function appears only with generic motors [Function A1 set at 0].
F73
Removing obstacles
If an obstacle is detected via the AST control on the board or by a safety edge input, the [Remove obstruction] function inverts
the gate leaf far enough to free the obstruction, then it stops.
F83
New user
Register up to a maximum of 250 users and assign a function to each one.
The operation can be carried out by using a transmitter or a BUS selector device (e.g. a keypad or transponder
reader). The board that manages the transmitters (AF) must be inserted into the connector.
U1
OFF = Deactivated
1 = Opening limit-switch and closing limit-switch
2 = Slowdown (Default)
3 = Opening limit-switch, closing slowdown
0 = N.O. (Default)
1 = N.C.
2 = N.C. for FA input, N.O. for FC input
OFF = Inversion caused by obstacle (Default)
ON = Remove obstruction
1 = Step-by-step
2 = Sequential
3 = Open
4 = Pedestrian/partial opening
Choose the function to be assigned to the user.
Press ENTER to confi rm.
The free position in the memory is shown intermittently for a maximum of 10 seconds.
During this phase, send the code from the control device.
Repeat the procedure to add other users.