CAME ZLX24MA Mode D'emploi page 76

Number of motors
Set the number of motors that control the gate.
Value 1 indicates that the M2 motor is being used
F46
Save data
Save user data, timings and confi gurations to the memory device (memory roll).
The function is displayed only when a memory roll card is inserted into the control board.
F50
Read data
Upload user data, timings and confi gurations to the memory device (memory roll).
The function is displayed only when a memory roll card is inserted into the control board.
F51
CRP address
Assign a unique identifi cation code (CRP address) to the control board.
The function is used where there are multiple operators connected to the same communication BUS using the
CRP protocol.
F56
Confi gure maintenance
Set the number of manoeuvres the operator can perform before a maintenance warning signal is generated.
The warning is displayed as an [SEr] message and signalled by 3 + 3 fl ashes every hour on the device
connected to the 10-5 output.
F58
RSE speed
Set the communication speed of the remote connection system.
F63
2 (Default)
1
OFF
ON (Run operation)
OFF
ON (Run operation)
1 to 254 (Default 1)
OFF (Default)
1X100 to 500X100
2 = 4800 bps
3 = 9600 bps
4 = 14400 bps
5 = 19200 bps
6 = 38400 bps (default)
7 = 57600 bps
8 = 115200 bps