Protecting The Environment; Rechargeable Battery Pack - DeWalt XR LI-ION DCN890 Manuel

Masquer les pouces Voir aussi pour XR LI-ION DCN890:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
7. Lift the rear of driver until at an angle and pull the driver out.
Refer to Figure N.
8. Replace driver and follow steps in reverse to reassemble
9. Ensure new driver slides smoothly through the gun before
full reassembly.
10. Return the driver, guide rods, bumpers, housing end cap,
and removable top stand back onto the unit. It is important
to try the alignment of the driver and the flywheel before
screwing the housing end cap back on to the unit. This
can be done by connecting a battery and pushing then
releasing the nose of the unit against a bench or hard
surface. This will start the motor spinning.
nOTE: When the driver and the flywheel are correctly
aligned, you will hear the motor coast back down from
full speed. If the driver and the flywheel are not correctly
aligned, the motor may not start up, may slow down much
faster than normal along with a loud grinding noise from
the unit. If this happens remove and reseat the driver
making sure the bumpers are seated correctly.

WARNING: Always test the unit by firing 19 mm pins
in Speed 1 into scrap material, to ensure that the tool is
working properly. If tool does not operate properly, contact
a recognized D
WALT service centre immediately.
e

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
Run the battery pack down completely, then remove it from
the tool.
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
16
All manuals and user guides at all-guides.com

Publicité

Table des Matières
loading

Table des Matières