Battery Type; Package Contents; Intended Use - DeWalt XR LI-ION DCN890 Manuel

English
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the
environment.
Charge D WALT battery packs only with designated
e
D WALT chargers. Charging battery packs other
e
than the designated D
D WALT charger may make them burst or lead to
e
other dangerous situations.
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).

Battery Type

The DCN890 operates on a 18 volt battery pack.
These battery packs may be used: DCB141, DCB142, DCB143,
DCB144, DCB145, DCB181, DCB182, DCB183, DCB183B, DCB184,
DCB184B, DCB185, DCB187, DCB546, DCB547DCB496, DCB497.
Refer to Technical Data for more information.

Package Contents

The package contains:
1 Concrete nailer
1 Charger (P2 models only)
2 Battery packs (P2 models only)
1 Kitbox (P2 models only)
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
10
All manuals and user guides at all-guides.com
WALT batteries with a
e
Visible radiation. Do not stare into light.
Length of nails.
13-57 mm
Nail thickness.
2.6–3.7 mm
Loading capacity.
33
Suitable nail collation angle.
15˚
Date Code Position (Fig. B)
The date code 23 , which also includes the year of manufacture,
is printed into the housing.
Example:
2017 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Trigger
1
Trigger lock-off
2
Speed selection switch
3
Sequential and Rapidcycle
4
switch
Contact trip release lever
5
Contact trip
6
Removable top stand
7
Stall release lever
8

Intended Use

Your concrete nailer is intended ONLY for use in driving pins
into structural steel OR concrete base materials OR fastening
wood to concrete. This tool has two operating modes, a
sequential operating mode and a unique rapid sequential
operating mode (RapidCycle). Read the section of the manual
Selecting the Mode before using the tool to make sure you are
selecting the proper mode for your application.
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
Your concrete nailer is a professional power tool.
Only D WALT pins recommended by the pin hardware
e
manufacturer and meeting applicable building code
requirements should be used in this tool.
This tool is intended for use by construction professionals.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
Low battery & jam/stall
9
indicator lights (x2)
Battery pack
10
Battery release button
11
Magazine
12
Magazine support leg
13
Magazine release lever
14
Pusher
15
Utility hook
16