Replacing Front Casters; Replacing Forks - Invacare Reliant 450 RHL450-1 Manuel D'utilisation

Replacing Front Casters

1. Place the lift on its side.
2. Remove the bolt and locknut that secure the existing front caster
assembly to the fork.
 The front caster assembly consists of two casters and a
washer in between.
The washer will fall out from between the two casters.
Washer will be reused. Examine and replace if worn.
3. Position the new/existing washer between the two new casters.
4. Line up the mounting holes in the new front caster assembly and the
fork.
5. Install the bolt through the fork and the new front caster assembly
and tighten securely with the locknut.

Replacing Forks

1. Place the lift on its side.
2. Remove the front or rear caster from the lift. Refer to Replacing Casters/Forks on page 48.
3. Unscrew the existing fork from the base.
4. Install the new fork onto the base.
5. Install the front or rear caster onto the lift. Refer to Replacing Casters/Forks on page 48.
Part No. 1078987
Locknut
Front
Casters
49
10 MAINTENANCE
Base
Fork
Washer
Manual/Electric Portable Patient Lift
Bolt