Checking And Tightening Mast Pivot Bolt - Invacare Reliant 450 RHL450-1 Manuel D'utilisation

10 MAINTENANCE

Checking and Tightening Mast Pivot Bolt

1. Lift up the back of the rubber boot and slide it off the mast along
the boom.
2. Check that the bolt is through the bracket and the locknut is tight
and secure.
3. If needed, do one or more of the following:
• tighten locknut and back-off the locknut 1/8 of a turn.
• replace the locknut.
4. Reposition the rubber boot.
Manual/Electric Portable Patient Lift
Washer
Bolt
Mast
46
Rubber Boot
Boom
Spacer
(if equipped)
Locknut
Bracket
Part No. 1078987