Assembling The Manual/Hydraulic Pump To The Boom - Invacare Reliant 450 RHL450-1 Manuel D'utilisation

Assembling the Manual/Hydraulic Pump to the Boom

CAUTION
DO NOT overtighten the nut and bolt. This damages
the mounting bracket.
1. Remove the shoulder bolt, washer and nut from the mounting
bracket on the boom assembly.
2. Unpack the pinch guard from the patient lift carton.
 The bottom of the hydraulic pump assembly will already
be assembled to the mast mounting bracket.
3. Cut the plastic-wrap that secures the boom and mast together.
4. Lift-up on the boom and place it on your left shoulder.
5. Let the hydraulic pump rest on the right-side of your chest and
rotate the shaft extension of the hydraulic pump assembly until it
lines-up with the mounting bracket holes in the boom assembly.
6. Turn the pinch guard 90° and place over the shaft extension of the
hydraulic pump.
7. Align the holes of the boom assembly mounting bracket with those
of the hydraulic pump and insert the bolt. Secure with washer and
nut.
 Be sure that the bolt is completely through the holes of the boom assembly mounting bracket and the manual/hydraulic pump assembly.
The boom assembly will pivot easily if the mounting hardware is aligned properly when the boom assembly is secured to the mast.
Part No. 1078987
17
5 ASSEMBLY
Mounting Bracket

Turn 90°
Manual/Electric Portable Patient Lift
Pinch Guard