Cleaning The Machine; Safety Thermostat - Manual Rearming; Correct Product Disposal - Bezzera BZ10 Manuel D'instructions

6.2 Cleaning the machine

Warnings: For the best results and in
compliance with current regulations,
change the water contained in the
boiler and pipings at every daily startup
of the machine.
These advices are indicative, the maintenance
and cleaning schedules depend on the use of the
machine.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and the filters.
Daily
1) Clean the cup holding grid and the drain ba-
sin.
2) Clean the body.
3) Clean the group's gasket with the brush sup-
plied.
4) Wash the group as follows: hook the filter
holder with the blind filter supplied to the
group) and initiate output for a few times.
5) Immerse the filter holder and the filters in hot
water for a few minutes to dissolve the grease
of the coffee, use a cloth or sponge to remove
it.
For washing and cleaning operations,
do not use solvents, detergents or
abrasive sponges but only specific
products for coffee machines. Wash
the body using a cloth soaked in water and/or
neutral detergents, and dry the surfaces well prior
to connect the machine to the electric line again.
Use water to wash the cup holding grid and the
drain basin.
Use water and neutral detergents to clean the tank
after removing it. When finished rinse thoroughly.
Replace the tank and insert the silicon tubes making
sure that the suction pipe touches the bottom.
6.3 Safety thermostat - Manual re-
arming
Warning!
described below is only relevant
to an installing technician who is
authorised by the manufacturer.
While the machine is working, the boiler resistance
may overheat and, cutting off power, sets off the
The operation
safety thermostat that prevents any further damage
to the boiler. To restore normal operations, resolve
the malfunction that triggered the safety thermostat
and restore normal conditions by pressing the red
button (RESET) (Fig. 07).

6.4 Correct product disposal

(electrical and electronic waste)
(Applicable in the European Union countries and
those countries with separate waste collection
systems).
The sign carried on the product or on its
documentation
product must not be disposed of with
other domestic waste at the end of its
life cycle. To avoid any damage to the environment
or to health, caused by unsuitable waste disposal,
the user is asked to separate this product from
other types of waste and to recycle it responsibly to
help the sustainable recycling of material
resources.
Domestic users are invited to contact the dealer
where the product was purchased or the local
office in charge of this matter for all the information
relating to separate waste collection and recycling
for this type of product.
Company users are invited to contact their own
supplier to check the terms and conditions of the
purchase contract.
This product must not be disposed of together with
other commercial waste.
25
BEZZERA BZ10
MOD.
indicates that the