Télécharger Imprimer la page

Chopin ALVEOPC graph Installation Rapide Et Premier Test page 2

Publicité

Les langues disponibles

Les langues disponibles

INSTALL YOUR ALVEOPC
A. Composition
**
AlveoPC
Burette
Burette
support
rod
Burette
holder
Cooling tip (x4)
B. Setting up
It is recommended to have AlveoPC delivered and installed by a technician authorized by CHOPIN Technologies.
Keep the packaging. You must use it when transporting the machine.
Indoor conditions of use: 20°C (68°F) ± 2°C (35°F) and a relative humidity of 65% ± 15%.
Put the AlveoPC on a horizontal and stable surface. Check the flatness with
the included spirit level.
Don't put the AlveoPC behind glass, especially if it is subjected to direct
sunlight.
Leave at least a 20-centimeter space around the machine to make sure it gets
enough ventilation.
C. Equipping the kneader
1.
Screw the burette support axis onto the base by making it go through the hole situated on
the upper part of the kneader crankcase.
2.
Slide the burette holder to the axis.
3.
Slot the burette into the clips.
4.
Then place the extracting plate by sliding it under the two spring leaves.
D. Alveograph installation
1.
Unscrew the upper plate by using the handle. Take it out of its three
guides so you can fully release the lower plate.
2.
Put the level onto the lower plate.
3.
Put the Alveograph at level by working on the adjustable feet. Turn
the level at 90 degrees, working on the feet again if you need to, until
the machine is perfectly horizontal.
4.
Make sure the locknuts are tight.
Flash drive software
Alveo/ kneading
cle-usb-alveopc.indd 2
27/03/2015 10:11:43
and instruction
machine connection
manual
(Ethernet)
Spirit level
Spatula
Oil dosing
Laminating
dispenser
rollers*
*When using it for the first time or after a thorough cleaning, it is necessary to oil these
accessories with an even layer of oil.
** The laptop isn't included
Alveo/PC
Power cable (x2)
connection (USB)
Funnel
Nozzle body
with nozzle
and plug
Semi-automatic
Knife*
cutter
High-pressure
hose
Extracting plate
Hose clip (x5)
Plates for resting
Roller table*
chamber
(x10)*
1
2
3
4
1
2
1. Locknut
2. Adjustable foot

Publicité

loading