Annex 1 - Fine Settings In The Wire Feed Unit - Magmaweld ID 500 M PULSE EXPERT Manuel D'utilisation

ID 500 M/MW PULSE EXPERT

Annex 1 - Fine Settings In The Wire Feed Unit

37
ANNEX 1 - FINE SETTINGS IN THE WIRE FEED UNIT
EN
1-Free Wire Feed Button
As long as the button is held pressed, the wire is fed and the gas valve does not operate. You can use this button to feed the wire into the torch.
2-Free Gas Button
When the free gas button is pressed, the gas will come for 30 seconds and if the free gas button is not pressed again within 30 seconds, the gas flow
will stop after 30 seconds. If the free gas button is pressed again within 30 seconds, the gas flow will stop as soon as it is pressed. With the free gas
button, gas flow is enabled and wire feed does not run. You can use this button to change the gas in the system after a gas change.
Free W re Feed Free Gas
Button Button
www.magmaweld.com USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU