Annex; Fine Settings In The Wire Feed Unit - Magmaweld RS 200 MK Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

28

Annex

ANNEX
EN

5.1 Fine Settings in the Wire Feed Unit

You can make fine adjustments through the panel which is above wire feeder,
1- Burn Back Adjusment Trimmer: In order to increase the burn back time, rotate the trimmer clockwise
with a slot screwdriver. In order to decrease the burn back time, rotate the trimmer counter-clockwise. Burn
back time can be adjusted in a range of 0 - 1 seconds.
2- Pre-Gas Adjustment Trimmer: In order to increase the pre-gas time, rotate the trimmer clockwise with a
slot screvdriver. In order to decrease the pre-gas time, rotate the trimmer counter-clockwise. Pre-gas time
can be adjusted in a range of 0 - 3 seconds counter-clockwise.
3- Post-Gas Adjustment Trimmer: In order to increase the post-gas time, rotate the trimmer clockwise with
a slot screvdriver. In order to decrease the post-gas time, rotate the trimmer counter-clockwise. Post-gas
time can be adjusted in a range of 0 - 3 seconds counter-clockwise.
4- Free Wire Feeding Button: While the switch is ON, the wire is fed at a slow speed until it touches to the
work piece. Then, wire feeding goes on at the adjusted speed.
5- Free Wire Feeding Button: The wire is fed as long as you push this button, but the gas ventile does not
work. You can use this function for inserting the wire to the torch.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
RS 200 MK - RS 250 MK - RS 300 MK - RS 350 MK - RS 400 MK
www.magmaweld.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rs 250 mkRs 300 mkRs 350 mkRs 400 mk

Table des Matières