Operation; Preparation And Connection Of The Torch - Magmaweld RS 200 MK Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

RS 200 MK - RS 250 MK - RS 300 MK - RS 350 MK - RS 400 MK

OPERATION

3.1 Connection to Mains
When plugging the power plug into the outlet, make sure that the power switch is set to "0".
• Check the 3-phase with a voltmeter before connecting the machine to
the mains. After detecting that each phase is 400V (± 40V), attach the
plug into the wall outlet.
• Start the machine with the on/off switch.
• Turn the machine off by turning the switch back to the "0" position
after hearing the fan sound and seeing the ammeter and voltmeter
lights are on.

3.2 Preparation and Connection of the Torch

• Use the torch according to the capacity of your machine and
the welding you will perform.
• Make sure that the diameters of the spiral and contact nozzle inside
the torch match the diameter of the welding wire you will use. Replace
the spiral and contact nozzle if necessary.
• To change the spiral, remove the nozzle, contact nozzle and adapter
respectively.
• Afterwards, remove the spiral nut on the torch connector side with
a wrench and extend the torch so that it is in flat position and remove
the spiral inside the torch.
• After inserting the new spiral into the torch, install and firmly tighten
the spiral nut.
• Cut the excess of the spiral from the torch head with a side chisel at
the point where the gas distributor (contact nozzle holder)
immediately ends as shown on the right, so that there is no gap
between the spiral and the contact nozzle. File the cut point to make it
blunt and burr free.
• Connect the torch to the torch connector and tighten the nut firmly.
www.magmaweld.com
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Figure 4 : Mains Connection
Contact Tip
Nozzle
Adapter
Figure 5 : Separation of Nozzle
and Contact Nozzle from the Torch
Nut of Liner
Figure 6 : Removal and
Installation of Spiral
Figure 7 : Cutting the Spiral Extension
Nut of Torch
Figure 8 : Torch Connection
Operation
19
EN
Liner

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rs 250 mkRs 300 mkRs 350 mkRs 400 mk

Table des Matières