Fuses; Error Codes - Magmaweld RS 200 MK Mode D'emploi

RS 200 MK - RS 250 MK - RS 300 MK - RS 350 MK - RS 400 MK
Failure
Fan is not operating
Machine operates noisily
Unstable and / or non-adjustable
welding current
Heater outlet is not operating

4.4 Fuses

F1
Fuse
F2
F3
F4

4.5 Error Codes

Error Code Error
Thermal
Protection
Err
Water Cooling
Unit Error
www.magmaweld.com
• The fuse has blown
• Fan motor failure
• Contactor failure
• Diode group failure
• The fuse has blown
10 A
Amperage
1 A
1 A
1 A
• The uptime of your machine may have
been exceeded
• Fan may not be working
• The front of the air inlet-outlet ducts
may be blocked
• The machine working environment
may be too hot or stuffy
• There may be an error in the water
cooling unit
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• Check the fuse
Reason
• Contact the authorized service
• Contact the authorized service
• Contact the authorized service
• Check the fuse. Contact the
Fast
Feature
Delayed
Fast
Fast
• Allow the machine to cool down by
Cause
• If the problem continues, contact the
• Check visually whether the fan is
• If the problem continues, contact the
• Open the front of the air ducts
• If the problem continues, contact the
• Make sure that the working
• If the problem continues, contact the
• Check water cooling unit connector
• Make sure there is water circulation
• If the problem continues, contact the
Maintenance and Service
Solution
authorized service
Motor and Card of the Wire Feeder
Protected Circuir
Cooler Fan
CO2 Heater
Card of Voltmeter / Ampermeter
Solution
waiting for a while. If the fault
disappears, try to use the machine at
lower amperage values
authorized service
working or not
authorized service
authorized service
environment of the machine is not
excessively hot or stuffy
authorized service
and torch inlets/outlets
authorized service
27
EN