Starting And Ending The Welding Process; Welding Parameters - Magmaweld RS 200 MK Mode D'emploi

RS 200 MK - RS 250 MK - RS 300 MK - RS 350 MK - RS 400 MK

3.7 Starting and Ending the Welding Process

• Determine the Coarse Adjustment ", Fine Adjustment" and Wire Feed Speed from the welding parameters
table of your machine according to the diameter of the wire you will use, the type of gas you will use and the
thickness of the material to be welded, and set your machine to these settings.
Wire Diameter
Material Thickness
Coarse Adjustment Range
Fine Adjustment
Wire Feeding Speed
Current
Voltage
• You can start welding after making sure that you comply with all safety rules and take the necessary
precautions.
• During welding, instantaneous welding voltage will be displayed in voltmeter and instantaneous welding
current will be displayed in ammeter.
When not welding, leave the torch in such a way that it does not touch the workpiece, the welding
• After you have finished working with the welding machine, allow the machine to cool down and turn the
pliers, the hood of the machine and the trigger does not remain pressed.
on / off switch to "0". Unplug the machine and close the gas cylinder.
• The welding parameters were obtained by horizontal welding with solid wire in laboratory conditions.

3.8 Welding Parameters

Values may vary depending on the application and ambient conditions.
RS 200 MK
www.magmaweld.com USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
RS 250 MK
Operation 23
EN