Selection And Replacement Of Wire Feed Rollers - Magmaweld RS 200 MK Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

20
Operation

3.3 Selection and Replacement of Wire Feed Rollers

• Open the cover of the wire feed part. You will see the four-roller wire feed system.
EN
3
5
4
4
6
6
5
Figure 9 : Wire Feed System
• Use wire feed rollers suitable for the material and diameter of
the welding wire you will use. Use V-grooved wire feed rollers for
steel and stainless steel, corrugated V-grooves for cored wires
and U corrugated ones for aluminum.
• If you need to replace the wire feed rollers, pull the pressure
roller lever toward your side and after lifting the pressure rollers,
remove the wire feed roller screws and remove the existing
rollers.
0.8 mm
Both sides of the rollers are marked according to the wire diameter used. Place the
rollers on the flange so that the wire diameter value you will use will be on the side
facing your side.
• After inserting the rollers, you will use, re-insert the screws and
lower the pressure rollers and lock the pressure roller lever onto
the rollers.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
1- Engine
2- Euro Connector
3- Pressure Roller Handle
4- Pressure Rollers
1
5- Wire Feed Rollers
6- WF Roller Screws
2
RS 200 MK - RS 250 MK - RS 300 MK - RS 350 MK - RS 400 MK
Figure 10 : Wire Feed Roller Removal
Figure 11 : Wire Feed Roller Placement
www.magmaweld.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rs 250 mkRs 300 mkRs 350 mkRs 400 mk

Table des Matières