Connection To Mains; Selection And Replacement Of Wire Feed Rollers - Magmaweld ID 500 M PULSE EXPERT Manuel D'utilisation

30 Operation

3.6 Connection to Mains

EN
Depending on the selected Mode, welding set current adjustment will
be done with the help of the pot. The setting will be performed by
turning the pot left or right.
• Start the machine with the on/off switch.
• Turn the machine off by turning the on / off switch back to off after hearing the fan noise and seeing the mains lamp is illuminated.

3.7 Selection and Replacement of Wire Feed Rollers

• When you open the cover of the wire feeding section, you can adjust the free gas and wire with the button on the side. You will see the four-roller
wire feeding system with an encoder structure. Thanks to its 4 WD system structure, the wire is mechanically driven with the power applied to the
four rollers. Even in negativities such as motor heating and increased friction, the wire feed speed will not change, provides excelent arc stability.
As soon as the machine is energized, the LED inside of the compartment will be active which will make it easier to replace the roller.
c
d
f
Figure 8 : Wire Feed System
• Use wire feed rollers suitable for the material and diameter of the welding wire you will use. Use V-grooved wire feed rollers for
steel and stainless steel, V-grooves type for cored wires and U-grooves type for aluminum.
• If you need to replace the wire feed rollers, pull the pressure adjustment screw toward your side (1) and after lifting the roller covers (2), remove the
existing rollers (3). (Figure 9)
• You must unlock the rollers before you can remove them. By reverse-turning the locking direction, the cavities
inside the wire feed roller must be overlapped with the protrusions on the wire feed body in order to unlock the
lock.
• Both sides of the rollers are marked according to the wire diameter used.
• Place the rollers on the flange so that the wire diameter value you will use will be on the side facing your side.
• Place the roller to be used so that the cavities inside the wire feed roller overlap the protrusions on the wire feed body (4). Turn to the right or left to
ensure that the locking sound is heard and that the wire feed rollers are in place. Then lower the pressure rollers (5) and lift the pressure roll lever to
lock it onto the pressure roller (6). (Figure 10)
(2) (2)
(1)
(3)
(3)
Figure 9 : Wire Feed Roller Removal
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
a- Motor
b- Euro Connector
a
c
c- Pressure Adjustment Screw
d
d- Top Wire Feed Rollers
b
e- Bottom Wire Feed Reels
f- Wire Feed Rollers Locking Mechanism
e
ID 500 M/MW PULSE EXPERT
Connect the poles according to the type of
the welding process.
(5) (5)
(6)
(4)
(4)
Figure 10 : Wire Feed Roller Placement
www.magmaweld.com