Arc Length Adjustment (Arc); Mig Curve - Magmaweld ID 500 M PULSE EXPERT Manuel D'utilisation

ID 500 M/MW PULSE EXPERT

3.4 Arc Length Adjustment (ArC)

When you press and hold the adjustment knob (9) for 3 seconds, the arc length function will be active. The factory setting is 0.0. You can change the
arc length adjustment in the range of + 7 / -7 by turning the same knob to the right or left. As it goes towards +7, the wire approaches the nozzle, the
arc length increases. As it goes towards -7, the wire approaches the welding metal and the arc length decreases. After the desired setting is made, the
setting is exited by pressing the same knob.

3.5 MIG Curve

Set Voltage
Voltage 0 - 25
Set Wire
Wire 0 - 25
Set Voltage
Voltage 0 - 25
Set Wire
Wire 0 - 25
ID 500 M/MW PULSE EXPERT
Parameter
Pre-Gas
Post Gas
Burn Back
Arc On Time
Arc Off Time
Wire Diameter
Thickness
Gas Type
Wire Type
Clicking Adjustment
Crater
Mode
Trigger
Method
Cooling Time
www.magmaweld.com
Crater Open
Slow Release
On
Pre Gas
Slow Release
Off
Crater Closed
Pre-Gas
Crater Open
Slow Release
On
Pre-Gas
Slow Release
Crater Closed
Off
Pre-Gas
Pnt Mode
On
Pnt Mode
Spot
Off
Pre-Gas
Value Range Factory Setting
0,0 - 9,9 sec
0,0 - 9,9 sec
25 - 0 - 25
0,2 - 9,9 sec
0,0 - 9,9 sec
0,8 - 1,6 mm
0,6 - 20,0 mm
82/18, 92/8, %100 Ar, %100 CO2, %97,5/2,5
SG/FE, Flux Rutil, Flux Basic, AIMg 4,5Mn, AIMg5, AIsi 5, AL 99,5
Active / Passive
Active / Passive
Synergic / Smart / Classic / Cell-Gauging / Rutile-Basic / Method
Method / 2 / 4 / 6
MIG / MAG - MMA
1 - 5 min
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Crater Burn Back
Burn Back
Burn Back
Crater
Burn Back
2- Position
MIG
0,1 sec
0,1 sec
0 step
0,2 sec
0,0 sec
1,0 mm
1,0 mm
Passive
Passive
2
MIG / MAG
1
Operation
Post Gas
Post Gas
Post Gas
Post Gas
Post Gas
4- Position 6- Position
MIG MIG
29
EN