Water Cooling Unit; Connection Of Interconnection Hose Package - Magmaweld ID 500 M PULSE EXPERT Manuel D'utilisation

16 Installation
EN
Figure 5 : Gas Connection

2.3.4 Water Cooling Unit

• Water cooling unit is a closed-circuit system consisting of a radiator, fan, pump and water tank used for cooling the torch.
If your machine has a water-cooling unit:
• Connect the cold (blue) water hose to the cold-water outlet on the water cooling system and the hot (red) water hose to the hot water inlet on the
water cooling system.
• Remove the water tank cover and fill the water tank with lime-free water containing antifreeze appropriate for the working environment
temperature. The coolant must be within the minimum and maximum values shown on the front panel of the unit.
• It is not suitable to use the water-cooling units with welding machines other than manufactured by Magma Mekatronik Makine ve Sanayi Ticaret A.Ş.
Water cooling units cannot be operated with external supply.

2.3.5 Connection of Interconnection Hose Package

• For easy transport of machines with hose package of 10 meters or longer, the wire feed unit and the interim package have been designed to be
detachable. Both ends of the long hose packages are the same and the connections on the machine front must be made with the connectors and
sockets on the back of the wire feeder.
• If interconnection hose package is 10 meters or longer, connect the wire feed unit with the hose package as follows.
Figure 6 : Long Hose Package Wire Feed Unit
Connections for ID 500 M PULSE EXPERT
Dirty and lime (hard) waters reduce the operating life of the torch and the pump.
If the coolant is below the minimum value, there is a possibility of damage and malfunction for the pump and
torch.
• There are 2 LEDs in front of the machine: The power LED will light as soon as the machine is activated and the water-cooling unit LED will light when
the water unit is activated.
• As soon as the machine starts welding, the water circulation will start and after the welding is completed, the water-cooling unit LED will remain on
during the time set in the menu. In case of any air inlet or problem, the water will not be recirculated.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• Connect one end of the tube hose (6) to the gas regulator (2) and tighten the clamp. Connect the other end
to the gas inlet at the back of the machine and tighten the nut.
• Open the gas cylinder valve (4) to check that the tube is full and that there are no leaks in the gas flow path.
If you hear a noise and/or detect a smell of gas as a leak indicator, examine your connections and eliminate
leakage.
Figure 7 : Long Hose Package Wire Feed Unit
Connections for ID 500 MW PULSE EXPERT
ID 500 M/MW PULSE EXPERT
www.magmaweld.com