Magmaweld ID 500 M PULSE EXPERT Manuel D'utilisation page 21

ID 500 M/MW PULSE EXPERT
PAGE 2
a) WIRE TYPE
Select the wire types
The wire type to be used must be selected correctly.
Setting Range
• Fe
• CrNiER308
• AlMg 4.5Mn
b) WIRE DIA. (WIRE DIAMETER)
Select the wire diameter.
The wire diameter to be used must be selected correctly.
Setting Range
• 0.8-1.6 mm
c) GAS TYPE
Gas type will be selected.
The type of gas to be used must be selected correctly.
Setting Range
• 82/18
• %100 Ar
d) THICKNESS
Material thickness is selected.
The material thickness to be used must be selected correctly.
Setting Range
• 0.6-20 mm
Example;
While the smart mode is selected, if you select argon gas and wire as SG 0.8, the value 0 will be displayed on the screen since this wire cannot be used
with argon gas. If you see the value of 0 on the screen, in any case something wrong has been selected in the menu such as method / wire type / gas
mismatch.
www.magmaweld.com
• 307 • CuAl8
• CrNiER316 • Al 99.5
• FCW-B • FCW-R
• 92/8 • 97,5/2,5
• %100 C02
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Operation
• CuSn • 309L
• AlSi 5 • AlMg 5
21
EN