Connections; Mains Plug Connection; Connecting The Grounding Clamp To The Workpiece; Connecting The Gas Cylinder - Magmaweld ID 500 M PULSE EXPERT Manuel D'utilisation

ID 500 M/MW PULSE EXPERT

2.3 Connections

2.3.1 Mains Plug Connection

For your safety, never use the mains cord of the machine without a plug.
• No plug has been connected to the mains cable since there may different types of
outlets available in plants, construction sites and workshops. A suitable plug
must be connected by a qualified technican. Make sure that the grounding cable
marked with and a yellow/green color is present.
• AFTER CONNECTING THE PLUG TO THE CABLE, DO NOT ATTACH IT TO THE OUTLET AT
THIS STAGE.

2.3.2 Connecting the Grounding Clamp to the Workpiece

• Firmly connect the grounding clamp to the workpiece as close as possible to the welding area.

2.3.3 Connecting the Gas Cylinder

• Use regulators and heaters that comply with international standards to work safely and achieve the best results. Make sure the size of the hose
connection of the gas regulator you are using is 3/8" (9.5mm).
• Open the gas cylinder valve (4), keeping your head and face away from the outlet of the valve and keep it open for 5 seconds. By this means,
possible sediment and impurities will be discharged.
• If the CO2 heater is to be used, first connect the CO2 heater (9) to the gas cylinder (3). After connecting the gas regulator (2) to the CO2 heater
(9), insert the plug of the CO2 heater (10) into the CO2 heater outlet on the back of the machine.
• If the CO2 heater will not be used, connect the gas regulator (2) directly to the gas cylinder (3).
www.magmaweld.com
1
2
Figure 4 : Gas Cylinder - Heater - Regulator Connections
1- Chain
2- Gas Regulator
3- Gas Cylinder
4- Gas Cylinder Valve
5- Flow Adjustment Valve
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Figure 3 : Power Plug Connection
3
6
7
8
9
4
5
6- Gas Hose
7- Flowmeter
8- Manometer
9- CO2 Heater
10- CO2 Heater Energy Cable
Installation
10
15
EN