Magmaweld ID 500 M PULSE EXPERT Manuel D'utilisation page 25

ID 500 M/MW PULSE EXPERT
PAGE 5
a) STARTING C. (STARTING CURRENT)
The starting current will be determined. It will operate as a percentage of the main current. It will be active when 6 trigger mode is selected. Even
though it allows setting for other modes, it will not work.
Setting Range
• %0-200
b) STARTING T. (STARTING TIME)
Start time will be set. It will be active when 6 trigger mode is selected. Even though it allows setting for other modes, it will not work.
Setting Range
• 0-5 sec.
c) FINISH C. (FINISH CURRENT)
Finish Current will be determined. It operates as a percentage of the main current. It will be active when 6 trigger mode is selected. Even though it
allows setting for other modes, it will not work.
Setting Range
• %0-200
d) FINISH T. (FINISH TIME)
The finish time will be set. It will be active when 6 trigger mode is selected. Even though it allows setting for other modes, it will not work.
Setting Range
• 0-5 sec.
www.magmaweld.com USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Operation 25
EN