Magmaweld ID 500 M PULSE EXPERT Manuel D'utilisation page 20

20 Operation
Pulse (Pulse MIG/MAG)
EN
When the Pulse welding method is selected in the METHOD menu, the modes will be as follows:
CLASSIC MODE
The classic mode will not be active in the pulse
method. When the Pulse method is selected,
you cannot see any value in the classic mode.
This is because in the Pulse method, all the
settings come from the software base of the
machine and the user is not allowed to make
any adjustments.
D.Pulse (Double Pulse)
When the D. Pulse (Double Pulse) welding method is selected in the METHOD menu, the modes will be as follows:
CLASSIC MODE
The classic mode is not active in the Double
Pulse method. When the Double Pulse
method is selected, you cannot see any value in
the classic mode. This is because in the Double
Pulse method, all the settings come from the
software base of the machine and the user is
not allowed to make any adjustments
When the D.Pulse option is selected, the D.Pulse parameters on pages 6 and 7 of the menu must be set. With double pulse structure, welding process
is done without deformation in the material especially in root pass process. Double pulse provides more aesthetic welding seams.
d) COOLING TIME
The machine determines how long the water in the system should circulate in the torch after the machine has cut off the welding process.
As soon as the machine starts welding, the water circulation will start and after the welding is completed, the water-cooling unit LED will remain on
during the time set in the menu.
Setting Range
• 1-5 min.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
SMART MODE
The settings are adjusted as in the MIG/MAG
method.
SMART MODE
The settings are adjusted as in the MIG/MAG
method.
ID 500 M/MW PULSE EXPERT
SYNERGIC MODE
The settings are adjusted as in the MIG/MAG
method.
SYNERGIC MODE
The settings are adjusted as in the MIG/MAG
method.
www.magmaweld.com