Technical Information; Machine Components - Magmaweld RS 200 MK Mode D'emploi

RS 200 MK - RS 250 MK - RS 300 MK - RS 350 MK - RS 400 MK

TECHNICAL INFORMATION

1.1 General Information
RS 200 MK, RS 250 MK, RS 300 MK, RS 350 MK and RS 400 MK are 3 phase step controlled, constant voltage
industrial compact MIG/MAG machines to weld all types of solid and flux cored wires in any kind of
fabrication and repair work shops. Wire feeding unit is a robust 4 wheel drive system which is placed inside
of the machine. This way of construction, harness and excessive cabling has been avoided. Even though you
can manufacture 24/7 with these machines in a big range of current scale, model RS 200 MK is optimized for
0.8 mm, model RS 250 MK, RS 300 MK , RS 350 MK for 1.0 mm, model RS 400 MK for 1.2 mm. These machines
are fan cooled and thermally protected against overheating.

1.2 Machine Components

1
2
3
4
5
1- Wire Speed Setting Button
2- Trigger Mode Switch
3- Torch Connector
4- Earth Clamp Cable Entry (-)
5- Braked Wheel
6- Digital Ammeter
7- Digital Voltmeter
8- Fine Step Switch
9- Closing and Coarse (Tension) Setting Switch
10- Welding Parameters Table
www.magmaweld.com
Figure 1 : Front and Back View
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
12
6
7
13
8
14
9
15
16
10
11
11- Swivel Wheel
12- Lifting Eye
13- Fuses
14- Gas Inlet
15- CO2 Heater Receptacle
16- Mains Cable
17- Handle
18- Drum Feeding
19- Gas Cylinder Safety Chain
20- Wheel
Technical Information 11
17
18
19
20
EN