Cleaning And Maintenance - Bartscher WB2110 Mode D'emploi

Turn the device off
• In case of longer breaks in the operation put all
temperature knobs into position "o", set ON/OFF
switch in position "O", and disconnect the device
from the power supply (pull the plug!).
• Put the spiral cable plug in the plug holder
located on the control panel.

6. Cleaning and maintenance

WARNING!
Before cleaning, switch the device off by pressing
ON/OFF switch and disconnect it from the power supply
(pull the plug!). Leave the device for cooling down and
drain water from the basins.
Never use the pressure washer for cleaning the device.
Make sure that no water gets into the device.
CAUTION!
Never use any coarse or abrasive washing agents or metal sponges as they
may scratch the device surface.
Never use any aggressive cleaning agents (products containing alcohol or
solvents).
Never clean the device with use of spiked or sharp objects.
Cleaning
o before cleaning remove GN chamber from the tank. GN chambers and lids
should be thoroughly cleaned with use of soft cloth or sponge in warm water
with small amount of gentle cleaning agent. After cleaning rinse in clean water
and thoroughly dry.
- 38 -