Bartscher WB2110 Mode D'emploi page 29

•
Check the power cord regularly for damage. Do not use the
appliance if the power cord is damaged. If this cable is damaged,
it must be replaced by customer service or a qualified electrician
in order to avoid dangers.
•
The supply cable must be disconnected from the socket
only by pulling the plug.
•
Never carry or lift the device by the supply cable.
•
In any case do not open the device housing. In case of
electrical or mechanical modifications the electric shock
hazard will occur.
•
Do not use any acid agents and make sure no water ingresses
the device.
•
Never operate the device with moist hands or standing on wet
floor.
•
Disconnect the device from the electric power supply.
when the device is not used,
-
in case of anomalies during operation,
-
before cleaning.
-
HOT SURFACE! Burn hazard!
Follow the safety instructions listed in order to avoid the hazard:
•
During the device operation the GN chambers become very hot.
Do not touch them with bare hands. Use designed pushing
handle for pushing the device.
•
After the device has been switched off it remains hot for some
time. Wait for cooling down before cleaning, moving, or carrying
it to another location.
- 25 -