Assembling The Locking Parts; Mounting The Solenoid; Mounting The Cover Plate - FIOR & GENTZ NEURO TRONIC Mode D'emploi

9.1 Assembling the Locking Parts

Make sure not to damage the sliding washer during the
assembly. Jammed sliding washer particles can cause lateral
play in the system joint.
1 Grease the axle bore of the locking pawl and of the toothed ring
as well as the friction surfaces of the bearing nuts slightly with
orthosis joint grease. Make sure that no grease enters the toothing
of the locking pawl and the toothed ring.
2 Put the bearing nut for the locking pawl into the opening of the
joint's lower part (fig. 12).
3 Mount the locking pawl (fig. 13).
4 Put the bearing nut for the joint axis into the opening of the joint's
lower part (fig. 14).
5 Grease the first sliding washer slightly on both sides with orthosis
joint grease and place it onto the joint's lower part (fig. 15).
6 Put the toothed ring on the front side of the joint's upper part so
that it is flush with the joint's upper part. The wavy cut-out has to
point in direction of the joint's upper part (fig. 16-17).
7 Mount the joint's upper part (fig. 18). Make sure that the joint's
upper part is placed without play.
8 Apply spray adhesive on one side of the second sliding washer and
adhere it to the cover plate (fig. 19).
9 Grease the other side slightly with orthosis joint grease.

9.2 Mounting the Solenoid

1 Place the pressure spring (2; fig. 20) onto the plunger (1).
2 Place the washer (4) onto the solenoid (5).
3 Slide the plunger through the solenoid fixation (3) into the sole-
noid.
4 Turn the solenoid into the solenoid fixation as far as possible.
5 Secure the solenoid by pressing it into the cover plate (fig. 21).

9.3 Mounting the Cover Plate

The lever of the cover plate is already preassembled. For the following
steps, the lever has to be set on the dot.
1 Clean the threads of the cover plate with LOCTITE® 7063 Super
Clean, if necessary.
2 Place the cover plate onto the system joint.
3 Screw in the first countersunk flat head screw (axle screw, S1;
fig. 22).
4 Screw in the second countersunk flat head screw (S2; fig. 23).
fig. 13
fig. 12
fig. 14
fig. 15
fig. 16
fig. 17
fig. 18
fig. 19
1
2
3
4
5
fig. 20 fig. 21
S1
S2
fig. 22 fig. 23
31