Converting Options Of The Neuro Tronic System Knee Joint; Maintenance - FIOR & GENTZ NEURO TRONIC Mode D'emploi

1 Press the MODE button at both controllers. First, a short beep is emitted. Keep the buttons pressed
until a second, longer beep is emitted after about 6-10 seconds.
2 Press the Auto and Lock button of the remote control at the same time for about four seconds. The LEDs
blink.
If the connection to both controllers has been successfully established, the LED at the remote control blinks
green twice. If the LED at the remote control blinks green only once, the remote control is only connected to
one controller. In this case, repeat steps 1-2. If establishing the connection has failed, the LED blinks red.
By acquiring our Bluetooth products, you have the possibility to use the apps. If there is an active connection
to an app, the blue LED on the controller blinks permanently and the controller cannot be operated with the
remote control.
The orthosis can only be controlled by the one remote control or app to which it is currently connected.
Other remote controls/apps have no influence on the orthosis.
You need a multi-purpose device with Bluetooth to adjust a controller with Bluetooth and to unlock the
Expert app once (see manual Multi-Purpose Device). You can switch from a controller without Bluetooth to
one with Bluetooth at any time, as it also fits into the retainer for the controller of the controller without
Bluetooth.

12. Converting Options of the NEURO TRONIC System Knee Joint

The NEURO TRONIC system knee joint can be converted into a NEURO MATIC system knee joint by exchang-
ing a few system components. To do so, please contact our Technical Support.

13. Maintenance

Check the system joint for wear and functionality every 3 months. Also check the functionality after every
maintenance carried out.
Joint Component
toothed ring and locking pawl
extension stop damper
sliding bushing
sliding washers
bearing nut
Especially the toothed ring and the locking pawl are subject to greater stress than other system components,
which is why you should replace them on a regular basis, regardless of visible signs of wear:
Activity
1 and 2
3
4
Problem
wear of the teeth
wear
wear
wear
wear
Point in Time
every 12 months
every 9 months
every 6 months
Measure
replacing
replacing
replacing
replacing, see paragraph 13.2
replacing
Measure
replacing
replacing
replacing
35