Publicité
Les langues disponibles
Les langues disponibles
On the deck, the sheet ropes are lead through
the eyebolts item 158-1 to the double block
item 165-1. This block is variably attached to a
cleat.
Lead the sheet ropes from the block back
through the free eyebolts to the sheet lead and
to the sail. Once again incorporate jib hanks in
the sheet rope to hang onto the sail.
Updated June 2016
The last photo shows the complete path of the
sheet rope.
The photo below shows how to fit the servo for
the rudder linkage.
Screw two pushrod connectors 206 into the
rudder arm of the servo and fasten the rudder
rods 208.
Finally, you can install the speed controller and
receiver and programme the remote control.
13. Installing the anchor and anchor winch,
flagpole, light board and navigation lights
Attach the anchor chain 195 to the anchor 194.
The chain can be coloured black with blacken-
ing agent, Krick order number 82001.
Page 39
©
Krick Modelltechnik Knittlingen
Publicité
